DELTA TMX Axle Set Pre-Order
* Made to order. Possible 3 week shipping delay *
Factory Built, by our GCM Team, this DELTΔ TMX axle set is designed specifically to match our DELTΔ Chassis setups. We build them right, by hand, grease them up, and pre-tap all the screw holes for easy installation at your end.
Front and Rear axle are included.
Check this spec list below.
Features:
Laser scintered nylon housing, bead blasted and dyed black. All holes final drilled at GCM, pre-tapped where applicable, and tested.
Plastic knuckles and rear bearing carriers are also installed. All parts are available as spares at GCM directly, or our Shapeways store.
Axle design promotes anti-squat geometry.
All metal gears, Steel treated shafts, and aluminum hexes are installed and pre-greased, ready for action.
Pre-Built:
1x front DELTΔ TMX nylon axle housing complete
1x rear DELTΔ TMX nylon axle housing complete
Full steering links
Tech Specs:
Width Axle Hex to Hex outside: 7.24 inch, 184mm
Full ball bearing assembly.
Front 3 link and trackbar required
Rear 4 link required
Captured Lower Link mounts
Fits standard 5mm driveshafts
